Holder Compatible for Dremel 100, 200, 395, Holder for Vise and Table mounting PN DH-47VT

Clamp arrived lightning fast and fit my Dremel 4300 perfectly. I may have over clamped it a bit but the crack propagated along through the lettering on the side. See the picture in how it makes a right angle along the "4" and then down through the "U". I used it for about one hour and was going slow to test my new CNC setup. 0.5mm depth cut and 20mm/min feed is pretty slow and shallow so the only thing I can think of is that I over tightened it or it had a weak spot. Regardless, I'd recommend the maker to remove lettering from the side of the clamp. Use a sticker or place somewhere else.

Keep It Simple Stupid! This little clamp couldn't be more simple, yet works perfectly. It is 3-D printed, and as a result of the cooling, the hole for the Dremel collapses slightly. But it a perfect light-press for the body of the tool, and holds it snugly without even tightening the screw. Probably not by design, but it couldn't work better. I have clamped this block in my bench vice holding the Dremel, and also clamped it down to my work bench. I like it so much I bought one for my son-in-law. Five stars!

Advertised as fitting the 4200 Dremel but it’s very difficult to fit it; I had to remove the screw and the base of this brace stays slightly bent after seating the Dremel into it as shown in ad picture. So if you wanted to secure the Dremel to a flat surface forget it. But it does fit well in my vice so it will still do the trick for me there. The plastic seems sturdy enough for long term use. So I’m satisfied.

The dremel 450 doesnt well fit in it! it was very tight. I didn't return it because i finally adapted it modifying the opening the hole with the same Dremel! the clamp is made by a screw which dificult to reach with a regular size screw driver. it would be recommended to provide a screw with knob or a quick release clamp to improve functionality. it doesn't include the screws to install the clamp and the holes to install are very small... Good example of a product no evaluated with the final customer prior to launch to the market.

This vise did not fit my Dremel 400XPR rotary tool. It wasn't even close.Fortunately I got it to fit a B&D rotary tool, with the help of a piece of rubber gasket.

Very nice. Was slightly large for my dremel model 395, so I added some stick-on rubber feet to the inner barrel to reduce the diameter a tiny bit.

Great tool holder that Dremel should have made and sold priced too high, but just a tip: don't clamp it too tightly lest you crack it.

I am giving five stars because it does exactly what I need it to do. However, mine did not come with the pinch bolt. Not the end of the world, just annoying when it says twice in the description that it does. Oh well, Its a common bolt that was easily found at a hardware store.