Bartoline Paint Predator Heavy Duty and Varnish Stripper 500 ml, Professional Strength, Non-Caustic Remover for Wood, Metal and Masonry

I’m really impressed by how effective it is. This product works incredibly fast at removing multiple layers of paint and varnish, even on tough, old surfaces. I applied it generously, covered the area with cling film, and let it sit for a while as recommended—this really helped the stripper penetrate and lift the paint with minimal effort. After scraping, the surface was practically clean with very little sanding needed. While it’s a bit messy and strong-smelling, the results speak for themselves. If you have a big stripping job, this is definitely a reliable and powerful solution that saves a lot of time and elbow grease.

Worked alright to get paint of my walls

Excellent paint remover as its very effective and does what it says. I used it on our landing floor to remove years old white paint marks. Just dropped a bit of it onto the floor, used a scraper to smother over the paint and few minutes later its already coming off really easy.

I ordered this for my pine garage rear door and was not impressed when I subsequently read a lot of the feedback. I’m afraid it only took the top coat of paint off and made no real impression on the 3 previous ones despite 2 further applications. So, in short, it has some value for me but nothing approaching a complete job.

I was using the traditional flammable paint stripper and ran out. Saw this and decided to try it and from the reviews appeared ok. However it is a water based white coloured stripper, apply with a brush and leave for an hour until the product reacts. This didn’t happen at all in places. It then advises to use a shave-hook to scrape off with. Then finally rub down with a scrubbing brush -DO NOT USE WIRE WOOL, which I was using with the traditional stripper. Wash down with detergent and water. The table looks nearly the same, the best place the varnish/stain came off was when I used wire wool. It was hard work too to remove. it was rubbish compared to traditional paint stripper which I am now going to buy again to complete the job.

Have put off stripping a 90 year old solid oak front door for the past 30 years. Finally got around to it. Used a heat gun first on about ten layers of paint but it still left a lot so bought this stripper. Did as it says on the tin and applied a thick coat as recommended in the instructions and left it for an hour. Within fifteen minutes I could see it was working so left it for an hour and applied a second coat.Again I left it for about half an hour and I was greatly impressed that the paint had gone to a paste that I could scrape off before it dried.I then used detergent and water on it and it had worked a treat, ready to be sanded.The smell was ok and all in all I found it good value and good quality.

worked fast and quite well, had to use second coat for stubborn bits then they came off very easily.

Didn’t work on removing paint from bath and bath even after 2 applications and using brio pad to gently remove