ddpaiHardwire Kit, Compatible with MINI Pro, Can Step Down The Voltage from The Car Battery's 12V/2A to 5V/2A, Enabling 24 Hours Parking Monitor

Got this for my DDPai mini 2, works great and easy to install , just keep in mind that it dies NOT come with the fuse tap cable nor the fuse to connect to the car fuse box, ended up going to a local auto parts to get the wire tap and the fuse , I got a 10Amp fuse and a small connector for the ground cable, overall works fantastic

This wiring kit helped me to install my DDPai camera in my F250. I wanted to take advantage of my Upfitter switches and control the camera with a switch, so needed a wiring kit. The length was more than adequate to run from the camera to the wiring connection behind and below the dash. The quality of the kit itself was fine, and once I hooked it up my camera received power. I'm going to buy it again to install a rear-view dash cam, and the length is good enough to reach from the back window to the dash to use another upfitter switch.

ok

This works great in our RV. Has enough wire to easily get to the fuse box and still be accessible while powering the dash camera where we want it to sit.

Bought the DDpai dash cam and used this to hardwire it to my fuse box. Nice clean installation that is very simple to do.It would be great if they included the fuse tap with it as others do but I wanted to stay with the ddpai cable since I had the same make camera.A trip to the AutoZone took care of that fuse tap business. Plenty of cable length to reach your fuse box.

perfect for a simple hardwire (key-switched) install so that your lighter socket is not being used by the dashcam, but voltage cutoff is too low (11.6v) for parking mode use and cannot be adjusted.

Integrates the DDPAI camera to initiate parking mode and automatically stops powering the camera when the vehicle battery voltage becomes low.

in use