Masterwon 2835 2 Pin 8mm LED Strip Connector - Strip to Wire Quick Solderless Connection for 12v Non-Waterproof Single Colour Led Strip Lights

Simple and effective connector.

Came on time works well.

Excellent, super easy to use and super strong fitting

Very easy to fit and secure, did the job nicely.

Does the job.

Obviously on the small side but easy to apply especially if you leave a small section of the peel back paper underneath the first connector location as this allows the strip to slide under the terminals of the clip connector.

These little clips definitely did the trick for connecting the LED strip to wire which enabled me to have a strip on each child with one power source. The clips are fiddly, but they’re built fairly well with a good snap into place. I didn’t need any additional tools either. My partner who doesn’t have long nails found them impossible to use however, so it may take a bit of a knack. Suitable for purpose though, and held the strip and wire together stead whilst I was positioning them which required some push and pull on the wiring.

Well made and easy to use, these are great little connectors. They’re also much smaller than I imagined and don’t add much depth when fitting. Useful for me as I was wiring up a cocktail cabinet.One side is for the LED strip and you push the end of a strip so that the electrodes go under a pair of contacts. Surprisingly easy and tight fitting. On the other side fitting fitting the wire is even easier. Just strip the ends and push the wires down into the holders then click shut. I used 18awg wire and it worked first time.If you use waterproof LED strip like I did then you have to fiddle about removing the silicon on top of the electrodes on the LED. I find it worked best when I removed just enough to expose the electrodes and no more.